Z max pos doesn't change after uploading
I'm trying to change the z max position which is defined in marlin as z home pos. When j change this value to anything, it still always the z position after homing is 253.3 after homing but if I go to...
View ArticleRe: Z max pos doesn't change after uploading
Again I don't use Marlin so I'm not totally sure but I've had a fiddle with the Marlin configuration tool here(N.B. I have no idea if that's recommended) and looking through the files it generated for...
View ArticleRe: Z max pos doesn't change after uploading
Asbo, thanks for the help. I've realised for some reason that problem is only when I use the lcd screen but now when I use repetier, it works fine and homes at the value I set but now when I jog z to...
View ArticleRe: Z max pos doesn't change after uploading
That might be caused by the printable height value, under printer settings in Repetier Host, being higher than what you've set in the firmware on the printer. This is a bit of a guess though. You...
View Article